If you’re looking for healthier water sanitisation solutions, Waterco’s Spa Poppits has the largest range of non-chlorine and non-bromine chemical products on the market to help you achieve a chlorine-free spa
Poppits is one of the few products that have already been designed to sanitise spas using hydrogen peroxide to oxidise the bacteria and organic materials in the water.
Free of harsh chemicals and chemical by-products Poppits is the latest ultimate water management system for spa sanitisation. Developed by Waterco, this system uses advanced oxidisation to purify spa water. Advanced oxidisation essentially raises the levels of active oxygen in the water, resulting in the removal of bacterial threats.
Endorsed by the National Asthma Council Australia, and the Asthma and Respiratory Foundation NZ as the ‘Sensitive Choice’ in pool and spa sanitisation, Poppits spa care range is specially formulated to be gentle on skin, kind to asthmatics, and good for the environment.
3 Simple Steps to a Chlorine-Free Spa:
- Heat And Read
- Balance Water
- Sanitise Your Spa
Poppits Peroxsil Test Strip
Preheat water in spa to at least 26 degrees then, using Peroxsil395 test strip (swirl 3 times and line up with colour indicators on test vial) check and record pH and alkalinity. It is important to make the reading within 30 seconds for it to be accurate.
Adjusting the PH & Total Alkalinity with Poppits One-Step Prep
Based on the reading on the strip you can determine how much of the POPPITS ONE STEP WATER PREP to add. See the chart below for how much to add. When adding Poppits One-Step Water Prep to spa water, pour it slowly into the spa with the jets turned on.
Adding Poppits Peroxsil395 Pool & Spa Sanitiser
For Spas up to 3000 litres add 380mL / 1000 litres and circulate for 30 minutes. For Swim Spas add 250mL / 1000 litres and circulate for 60 minutes.
For more information